The function of the wardrobe is mainly to store, sort and organize clothes. As the saying goes, time is money. Installing wardrobe lights can help us quickly find matching clothes. However, we still need to remind you to install wardrobe lights to avoid thundering, so as to avoid damage to the lights. Danger. Wardrobe lights can make a dull wardrobe bright and cheerful, which can be said to have a lot of benefits. So what kind of thunder can not be stepped on when installing wardrobe lights?

　　1. The required length of the light strip should be measured in advance and purchased as a whole. Because the light strip is usually in units of 1m, when installing the light strip, you can only cut it from the mark of the scissors mouth, so that it will not affect the operation of the circuit. If you cut it at will, the whole unit will not light up.

　　2. It is forbidden to power on during the installation or assembling of the light strip. The power can only be turned on when it is installed. In addition, when the light strip is in a roll, please do not turn on the light strip. Because when the whole roll of light strip is piled up in a ball, the magnetic field brought by the coil is very strong, and the heat is also large, which is easy to cause fire, so it must be arranged into a strip before use.

　　3. During the installation and use of the light strip, please do not knock the light tube or drop it to vibrate. Because if the solder joint of the LED light bar has a virtual soldering phenomenon, the vibration may cause the solder joint to fall off and the lamp bead does not light up. Dropping may also cause damage to the LED flexible light strip chip.

　　4. The power supply voltage should be consistent with the lamp marked. Please see if your light strip is a high-voltage light strip or a low-voltage light strip. If it is a 12V or 24V low-voltage light strip, it needs to be used with a transformer.

　　5. If you find that the lamp body is damaged during the installation process, please cut off this part and do not continue to use this part. So as not to cause danger.

　　6. Pay attention to the installation environment. The light strip cannot be installed in the water, high heat, flammable, and explosive environment. It is necessary to ensure that the use environment is well ventilated. If the light strip is installed in the light trough of the wardrobe, the dust in the trough must be cleaned up, because the dust may cause danger when heated, pay attention to the waterproof level of the light strip. If it is used in a humid environment, glass glue or other methods must be used at each interface Seal the joints to avoid danger caused by water entering the joints.

　　7. Tandem light strips. Only two strips with the same specifications and voltages can be connected to each other. Note that the total length of the series connection cannot exceed the maximum allowable length. When connecting the power supply or connecting two light strips in series, make the wires in the light strip exposed about 2-3mm, cut them clean with pliers, leaving no burrs, and then connect with the male pin to avoid short circuit. When the light strips are connected in series, one segment can be lit for each segment connected in order to find out whether the positive and negative poles are connected in time.