Perhaps many people's understanding of lights is still at the stage where one lamp solves the problem in one room, which is not the case for modern decoration a long time ago. One lamp for one room is the stage of "just live in". With the improvement of economic conditions, everyone's requirements for decoration have risen to the stage of "live well". Taking kitchen lighting as an example, the easiest way is in the middle Install a few lights on the top and a few cabinet lights inside and under the cabinets. Now a good kitchen requires at least two local lighting, one is under the wall cabinet and the other is above the sink.

          The installation of the cabinet light is beautiful and practical. The wiring and slotting are pre-designed, the size and position of the lamp are determined, and the wire is routed inside, so that after the cabinet light is installed, the wire cannot be seen when the lamp is turned on. Affects the viewing, but also practical and convenient.

          The installation of panel lights is similar to cabinet lights, which are divided into embedded installation, suspended installation, and ceiling installation. Embedded installation is to embed the panel light in the ceiling, place the power supply on the side and connect it with a wire, put the panel light into the frame to make them match each other, and make the lamp face down, adjust the angle until it is as smooth as the ceiling. Suspended installation is to fix the fixed parts on the four corners of the panel light, then add soft pads, and use screws to embed the fixed parts in the ceiling. Ceiling installation needs to open holes through the ceiling according to the corresponding size of the lamp, and connect the wires and lamps correctly. Press the spring buckles on both sides of the luminaire until it is vertical, and slowly install the luminaire into the open ceiling.

            Cabinet lights are installed under the wall cabinets. The Roca series-5W cabinet lights are recommended. You only need to swipe near the sensor of the light to turn on the light and turn off the light. You can adjust the light according to the brightness you want, which is more convenient to use. The light wire can be reserved in the upper cabinet in advance, and then drilled and threaded at the bottom of the cabinet. It doesn't matter if you don't wire it in advance, except that you can wire it directly. When these cabinet lights are installed in the kitchen, you will find that cooking at night is indeed much easier.